IBM System Storage DS3000

Show controller NVSRAM
The show controller NVSRAM command returns a table of values in the controller NVSRAM that is
similar to that shown in this example. With the information from the table, you can modify the contents
of the NVSRAM by using the set controller command. This example shows information for a controller
in slot A in a controller enclosure. You can produce a similar table for a controller in slot B, or you can
produce a table for both controllers.
Show volume
The show volume command returns information about the volumes in a storage subsystem.
STANDARD VOLUMES------------------------------
SUMMARY
Number of standard volumes: 5
See other Volumes sub-tabs for premium feature information.
NAME STATUS CAPACITY RAID LEVEL VOLUME
GROUP LUN
A-16 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide