IBM System Storage DS3000

DS4000: N/A
DS5000: N/A
Set Disk Pool (Modify Disk Pool)
DS3000: 7.83.xx.xx and later
DS4000: N/A
DS5000: N/A
Set Drawer Service Action Allow Indicator
DS3000: N/A
DS4000: N/A
DS5000: 7.60.xx.xx
Set Drive Channel Status
DS3000: 6.17.xx.xx
DS4000: 5.2x.xx.xx
DS5000: 7.3x.xx.xx
Set Drive Hot Spare
DS3000: 6.17.xx.xx
DS4000: 5.2x.xx.xx
DS5000: 7.3x.xx.xx
Set Disk Drive Service Action Allow Indicator
DS3000: 6.17.xx.xx
DS4000: 5.2x.xx.xx
DS5000: 7.3x.xx.xx
Set Drive State
DS3000: 6.17.xx.xx
DS4000: 5.2x.xx.xx
DS5000: 7.3x.xx.xx
Note: For version 7.60.xx.xx, you can change the drive parameter to accommodate the enclosures
with internal disk drawers.
Set Enclosure Alarm
DS3000: 6.17.xx.xx
DS4000: 6.16.xx.xx
DS5000: 7.3x.xx.xx
Set Enclosure Identification
DS3000: 6.17.xx.xx
DS4000: 6.1x.xx.xx
DS5000: 7.3x.xx.xx
Note:
v 6.14.xx.xx adds support for DS4800.
v 6.16.xx.xx adds support for subsystems and enclosures that set enclosure IDs through the
controller firmware.
3-20 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide