Parameters
Parameter Description
repositoryRAIDLevel The RAID level for the mirror repository logical drive.
Valid values are 1, 3, 5,or6.
repositoryDrives The disk drives for the mirror repository logical drive.
EnclosureID1,drawerID1, slotID1 ...
enclosureIDn,drawerIDn,slotIDn is for enclosures with
multiple disk drive drawers. For enclosures without
disk drive drawers, use enclosureID1,slotID1 ...
enclosureIDn,slotIDn. Enclosure ID values are 0 to 99.
Drawer ID values are 1 to 5. Slot ID values are 1 to
32. Enclose the enclosure ID values, the drawer ID
values, and the slot ID values in parentheses.
repositorysubsystemUserLabel The alphanumeric identifier (including - and _) that
you want to give the new subsystem in which the
mirror repository logical drive will be located. Enclose
the subsystem identifier in square brackets ([ ]).
repositorysubsystem The name of the mirror repository subsystem, where
the mirror repository logical drive is located. (To
determine the names of the subsystems in your
storage subsystem, run the show storageSubsystem
profile command.)
driveType The type of drive that you want to use in the mirror
logical drive. You cannot mix drive types.
You must use this parameter when you have more
than one type of drive in your storage subsystem.
Valid drive types are :
v fibre
v SATA
v SAS
If you do not specify a drive type, the command
defaults to fibre.
Use this parameter when you use the
repositoryDriveCount parameter.
3-36 IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
To Next Page
Loading...
Need help?
General