vii
New2001
TABLE OF CONTENTS
■ Auto power ON ····································································128
■ Time-out timer ······································································128
■ PTT lock ···············································································128
■ Font size ··············································································129
■ Display backlighting ·····························································129
■ LCD contrast ········································································129
■ Cloning function ···································································130
■ Resetting··············································································131
14 TROUBLESHOOTING ·····························································132
15 SPECIFICATIONS ···························································133–134
16 OPTIONS ········································································135–137
■ Optional HM-75A REMOTE CONTROL SPEAKER
MICROPHONE ····································································136
■ Connecting to the [DATA/SP/MIC] jack ································ 137
INDEX ················································································· 138–143
17 CE ·················································································146–147
WATERPROOF NOTICES
• BE CAREFUL! The transceiver employs waterproof con-
struction, which corresponds to IPX7 of the international
standard IEC 60529 (2001). However, once the transceiver
has been dropped, waterproofing cannot be guaranteed
due to the fact that the transceiver may be cracked, or the
water-proof seal damaged, etc.
• MAKE SURE the [DATA/SP/MIC] connector cap, flexible
antenna and battery pack are securely attached to the
transceiver, and that the [DATA/SP/MIC] connector cap,
antenna and battery pack are dry before attachment. Ex-
posing the inside of the transceiver to water will result in
serious damage to the transceiver. After exposure to water,
clean the battery contacts thoroughly with fresh water and
dry them completely to remove any water or salt residue.
• NEVER remove or insert the battery pack when the trans-
ceiver is wet or soiled. This may result water or dust get-
ting into the transceiver/battery pack and may result in the
transceiver being damaged.
• IMPORTANT: KEEP the transceiver’s [DATA/SP/MIC] con-
nector cap attached when the speaker-microphone is not
in use. If the cover is not attached, water will get into the
transceiver. More over, the terminals (pins) will become
rusty, or the transceiver will function abnormally if the con-
nector has become wet.
• NEVER immerse the connector in water. If the connector
becomes wet, be sure to dry it BEFORE attaching it to the
transceiver.
To Next Page
Loading...
Need help?
General
