IPCGansow CT 230 BT 85 - Page 64

PLDC01938
REVISION 00
01/06/2011
TECHNICAL DEPT.
Stavale
- date 05/09/2011 53/195
Reassembly
1 Insert the screws of the nuts F into the bushing G1 respecting the insertion position and screw up with a
maximum torque of ~ 20 Nm (~ 2.0 Kgm).
2 Wire the new Anderson connector A on the motor (or motors) replaced, respecting the polarity of the power
wires on the motor dismounted previously.
3 For the left motor, the polarity of the power wires must be reversed with respect to the polarity shown on the
connector, the red power wire to the motor must be connected to the “-“ negative sign on the connector,
while the black power wire to the motor must be connected to the “+” positive sign on the connector.
4 For the right motor, the polarity of the power wires must respect the polarity shown on the connector, the red
power wire to the motor must be connected to the “+“ positive sign on the connector, while the black power
wire to the motor must be connected to the “-” negative sign on the connector.
Not respecting polarity when connecting the brush motor wiring will not cause the
machine to malfunction but may affect the washing phase.
i
PHOTO 121
F
F
F
PHOTO 122
A
RIGHT
PHOTO 123
A
LEFT