List of Figures
P/N 960-000164R_Rev. 3 {EDP #213631} © 2018, JAPAN CASH MACHINE CO., LTD.
Page
iPRO-RC™ Series Banknote Recycler
Figure 4-1 Power Source Circuit Board Removal .................................................. 4-1
Figure 4-2 Lifter Motor Encoder Circuit Board Assembly Removal .......................4-2
Figure 4-3 Connector & Harness Removals .......................................................... 4-2
Figure 4-4 Recycler CPU Circuit Board Removal ..................................................4-2
Figure 4-5 Emission Side Double Note Sensor Removal ...................................... 4-3
Figure 4-6 Lifter Motor Bracket Removal ...............................................................4-3
Figure 4-7 Lifter Motor Assy Removal ...................................................................4-3
Figure 4-8 Rear Frame & Middle Frame Removal ................................................ 4-3
Figure 4-9 Rear Transport Assy Removal ............................................................. 4-4
Figure 4-10 Left Frame Plate Removal ...................................................................4-4
Figure 4-11 Frame Guide 4 Removal ...................................................................... 4-4
Figure 4-12 Full Sensor PTs and End Sensor LEDs Removal ................................4-4
Figure 4-13 Frame Guide 3 Removal ...................................................................... 4-4
Figure 4-14 Full Sensor LEDs, End Sensor PTs and Lifter
Home Position Sensor LED/PT Removal ............................................. 4-5
Figure 4-15 Upper & Lower Flapper Pusher Lever Solenoid Removal ...................4-5
Figure 4-16 Flapper Open/Close Circuit Board Removals ...................................... 4-6
Figure 4-17 Banknote Transaction Sensor/ Transport Unit Encoder
Circuit Board & Double Note Sensor Removal ....................................4-6
Figure 4-18 Banknote Transaction Sensor & Box Detection
Circuit Board Removal .........................................................................4-6
Figure 4-19 Recycler Encoder Circuit Board Removal ............................................ 4-7
Figure 4-20 Gear & Shaft Removal .........................................................................4-7
Figure 4-21 Recycler Transport Motors Removal ....................................................4-7
Figure 4-22 Rear Transport Upper Frame & Shaft Removal ................................... 4-8
Figure 4-23 Timing Belt Cover Removals ................................................................ 4-8
Figure 4-24 Timing Belt/Pulley Removal ................................................................. 4-8
Figure 4-25 RC Centering Guide Removal ..............................................................4-9
Figure 4-26 End Lever Removal .............................................................................. 4-9
Figure 4-27 Pick Roller Removal .............................................................................4-9
Figure 4-28 RC Course Assy. Removal ..................................................................4-9
Figure 4-29 Transport Race Shaft Removal ............................................................4-9
Figure 4-30 Feed Roller Removal ......................................................................... 4-10
Figure 4-31 Flapper Removals .............................................................................. 4-10
Figure 4-32 Spring Removals ................................................................................4-10
Figure 4-33 Impeller Shaft Removals ....................................................................4-10
Figure 4-34 Impeller & Stop Roller Removal ......................................................... 4-11
Figure 4-35 Pusher Mechanism Removal ............................................................. 4-11
To Next Page
Loading...
