Chapter 12: Qualification Reports
ValProbe RT User Manual 122
The body of the report is arranged by Groups. For each Group the Detailed report contains
pages detailing the sensor measurements, the Statistical calculations, Lethality calculations (if
defined), and the Saturation Temp and Pressure calculations (if defined). The last pages of the
report lists System and Event messages along with a footer as defined in report options.
Figure 161: Qualification Detailed Report
12.3. Qualification Summary Report
Summary Reports are created from raw encrypted Qualification files and for each Group
provide a summary of all sensor measurements during a Qualification study. All calculations
performed in the Summary report are set by the storage rate as defined in the Setup. The
Main report header provides the same traceability information for the study as defined in the
Detailed report.
The remaining sections of the Summary cover pages include the same information as defined
in the Detail Report.
The body of the report is arranged by groups. For each group, the Summary report contains
two sections, temperature data tables and temperature summary data tables.
The Temperature Data Table includes a listing of each sensor in the Group, the Min, Max,
Avg, Lethality, and Max-Min values for each cycle defined in the study (i.e., Heat up,
Exposure, Cooldown).
Included at the bottom of the Temperature Summary is a data summary for each cycle for all
sensors in the group. Table calculations include:
• Cycle start time and date
• Cycle duration
• Min of Min, Sensor ID, date and time of occurrence
• Max of Max, Sensor ID, date and time of occurrence
• Max range
• Max spread and time of occurrence
• Min and Max accumulated Lethality and from which sensor
• Avg of Avg
• Max of all (Max - Min) for all sensors contained in the group.
To Next Page
Loading...