Kaye ValProbe RT - Transportation Regulations; FCC Compliance Statement

Appendix B. Regulatory Compliance and Agency Approvals
ValProbe RT User Manual 158
B.5 Transportation Regulations
Batteries: Base Station shipping package has Lithium ion rechargeable batteries and Logger
shipping package has Lithium primary battery. Both shipping packages are classified as non-
restricted (can be shipped by common carrier without special requirements). Batteries should be
separated from each other during shipment to prevent shorting.
Magnets: Base Station shipping package has magnets and packaging is compliant to air
shipment as per IATA dangerous goods regulations as per UN 2807 magnetized material
standard under packing instruction 953 guidelines.
B.6 FCC Compliance Statement
FCC §15.19 Labelling requirements:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
FCC §15.21 Information to User: Changes or modifications that have not been explicitly
approved by the body responsible for the compliance with the requirements may void the
authorization of the User to operate the device.
Kaye ValProbe RT Base Station FCC ID: 2AJQZ-VPRT-BS1
Kaye ValProbe RT Logger FCC ID: 2AJQZ-VPRT-L1
FCC 47 CFR §2.1091 RF Radiation Exposure statement:
This product complies with FCC 47 CFR §2.1091, Canada ISED RSS-102 and European
committee for Electrotechnical standardization (CENELEC) EN 62311:2008 limits for exposure to
radio frequency.
WARNING: To satisfy FCC RF exposure requirements for mobile transmitting devices, a
separation distance of 20 cm or more should be maintained between the
antenna of this device and persons during device operation. To ensure
compliance, operations at closer than this distance is not recommended. The
antenna used for this transmitter must not be co-located in conjunction with
any other antenna or transmitter.
ATTENTION ! Pour satisfaire aux exigences d’exposition FAC RF pour les dispositifs de
transmission mobile, une distance de séparation de 20 cm ou plus doit être
maintenue entre l’antenne de cet appareil et les personnes pendant le
fonctionnement de l’appareil. Pour assurer la conformité, les opérations plus
rapprochées que cette distance ne sont pas recommandées. L’antenne utilisée
pour cet émetteur ne doit pas être co-localisée en conjonction avec une autre
antenne ou émetteur.