Kaye ValProbe RT - Unpacking

Chapter 1: Kaye ValProbe® RT System
ValProbe RT User Manual 4
The Base Station collects and stores the data from all Loggers and provides communications
to the Console. The default communication between the Base Station and the
Console/Docking Station is via direct Ethernet connection utilizing a pre-configured Static IP
address. As an additional option, connect the Base Station and Console / Docking Station to a
network utilizing dynamic DHCP address, DHCP addresses are software configurable.
The Validation Console is pre-loaded with the ValProbe RT software and is the primary
interface for the operator. The User utilizes the software to configure Setups, Start/ Stop
Qualifications, perform Sensor Verifications, create reports, store Validation studies, and
provide a real-time display. All commands and action generated at the Console are
transmitted to the Base Station and broadcast, via RF, from the Base Station to the Loggers.
1.3. Unpacking
Unpack the Kaye ValProbe RT Loggers, Base Stations, Kaye Validation Console, and
accessories carefully and inspect them for any damage that may have occurred during
shipment. If there is shipping damage, notify the carrier immediately. Verify that the following
are present:
S.No
Base Station Package
Qty
1
ValProbe RT Base Station
1
2
Power adapter for Base Station
1
3
Power cable for adapter
1
4
Kaye #200-166 3.7 V lithium secondary (rechargeable) batteries
2
5
Shielded Ethernet cable 2 meters
1
6
IRTD cable
1
7
Bath cable
1
8
User manual
1
9
Logger opener
1
10
Logger wakeup device
1