Chapter 2: Kaye ValProbe RT Hardware
ValProbe RT User Manual 19
Battery Replacement
Kaye recommends replacing the battery when there is 10% battery life remaining. The battery
percentage indicator (text color) is based on the battery percentage value, between
0%-19% in Red, 20% to 49% in Orange, and 50% to 100% in Green.
Battery replacement is a three-step process involving:
• Removing the Existing O-ring and Battery
• Installing the Replacement O-ring and Battery
• Resetting the Battery Odometer
Open the Logger and Remove the Existing O-ring and Battery
WARNING! To ensure that the Logger maintains its waterproof and pressure-tight seal,
a thin coat of grease was applied to the O-ring. The grease material is
KRYTOX GL-203, and safe handling and storage practices should be
followed. KRYTOX is a registered trademark of DuPont Chemicals. Material
Safety Data information is available from DuPont Chemicals.
ATTENTION ! Pour garantir que le Logger conserve son étanchéité à l'eau et à la
pression, une fine couche de graisse a été appliquée sur le joint torique.
La graisse est du KRYTOX GL-203, et des pratiques de manipulation et de
stockage sûres doivent être suivies. KRYTOX est une marque déposée de
DuPont Chemicals. Les informations sur les données de sécurité sont
disponibles auprès de DuPont Chemicals.
• Slide the Logger opener over the probe tip and onto the top of the Logger. Unscrew the
bottom cup while holding the opener firmly against the probe base.
Figure 23: Open Logger
• Remove the battery cap by pressing down on it and turning counterclockwise.
• With the cap removed, pull the battery out of the enclosure.
• To remove the O-ring, lift it from the groove and slide off in the direction of the probe
tip.
Figure 24: Remove the Old Battery and O-ring
To Next Page
Loading...