Chapter 3: ValProbe RT System Connections
ValProbe RT User Manual 28
Base Station Wakeup Magnet
A powerful neodymium magnet is located behind the LED panel to the Kaye logo. The magnet
is used to wake up Loggers from sleep mode prior to connection and execution of a
Qualification or Verification. Swipe the base of the Logger slowly over the Kaye logo. The
Base Station LED’s flash along with a buzzer sound to state the Logger has been woken. The
magnet is only used to awaken a Logger and cannot stop a Logger. Stopping a Logger during
Qualification or Verification is controlled by the completion or cancellation of a study by a User.
Loggers return to a sleep mode if during Idle mode, there is inactivation of communication for
15 min. Keep any magnetic sensitive devices away from the Base Station. In addition to the
Wakeup device the Base Station can also be used to wake up loggers.
Figure 37: Wakeup Magnet
Wakeup Device
Figure 38: Wakeup Device for Logger
The Wakeup device is a plastic enclosure with a permanent magnet inside. It helps to wake
Loggers from Sleep mode. The powerful neodymium magnet is located behind the Kaye logo.
Keep the Wakeup device away from magnetic sensitive parts. To wake a Logger from sleep
mode swipe near the Kaye logo on the Wakeup Device.
CAUTION! The Base Station and Wakeup device contain magnets and may affect
devices.
Attention ! La station de base et le dispositif de réveil contiennent des aimants et
peuvent affecter les appareils.
To Next Page
Loading...