Chapter 4: Initial ValProbe RT Software Setup
ValProbe RT User Manual 46
Optionally, you may enter a designated Phone number and Email ID as contact details
that are for contact information only. Select Save to save the information.
The User Management screen displays a list of active Administrators accounts. The default
Administrator Kaye account is deleted.
Only Administrator accounts can enter the admin tile and create new Operator accounts.
Unlike Administrator level accounts, an Operator account is added by the Administrator it is
assigned a temporary password which will be required to be changed by the Operator when
they first login. When creating a new Operator account, the Username is added to the active
User list. To create an Operator account:
Enter a new Username in the Name textbox.
Note: User IDs must be unique. Once a User ID has been used, it cannot be used again.
There is a limit of 500 Users, creation of a 501
st
User causes a warning message to
appear and does not allow any further User creation.
Enter the new account’s User identification in the User ID textbox.
User IDs are any combination of numbers and characters. The User ID and password
are case sensitive. A User ID may not be used by more than one account.
Enter a temporary password for the User in the Password textbox.
The temporary password is any combination of numbers and characters. The User must
change this password on their first ValProbe RT software login.
Enter the temporary password again into the Confirm Password textbox.
Note: Please record the new User ID and temporary password.
Note: A User account is not active until the User changes their temporary password after
logging in for the first time.
Define the Title.
To Next Page
Loading...