106 N9030B PXA Signal Analyzer Service Guide
Instrument Messages
Event Messages
–221 Settings conflict; Param
only available when
Frequency Mode is Swept
SCPI only message. This parameter is only available when
the Freq mode is set to Swept. Change the Freq Mode to
Swept
–221 Settings conflict; Param
only available when valid
cal data exists
SCPI only message. The ‘Apply Calibration’ parameter is only
available when the stored cal data matches the current
setup. Perform a fresh ‘Calibrate Now’ or change setup such
that current cal data is valid.
–221 Settings conflict; Preamp
gain is not available in
this Mode
Preamp gain correction is not available in some Modes or
Measurements
–221 Settings conflict; Preamp
unavailable with electronic
attenuator on
The electronic attenuator is on. Internal preamp cannot be
used while you are using the electronic attenuator.
–221 Settings conflict; Reference
marker must be in same
window
A delta marker and its reference must be in the same
window. This error occurs when you try to turn on a delta
marker who’s reference is in a different window.
–221 Settings conflict; Relative
Trigger needs hardware
support for this meas
To do Relative Triggering in this measurement requires
optional hardware that is not present in this analyzer.
–221 Settings conflict; Scale
Type = Lin is not available
when Normalize is on
Only the Log amplitude scale is available in Normalize, since
the results are always presented as a dB ratio.
–221 Settings conflict; Settings
conflict; Pre-trigger is
insufficient for demod.
Decrease Trig Delay.
–221 Settings conflict; Signal
Track is not available when
Freq Scale=Log
The signal tracking feature cannot be used when you have
selected a log scale for the frequency axis.
–221 Settings conflict; Signal
Track is not available with
Continuous Peak
The signal tracking feature cannot be used while you are also
using the continuous peak function.
–221 Settings conflict; Signal
Track is only available in
Swept SA measurement
The signal track functionality can be used when making a
swept SA measurement. It is not available in the SA
measurement when you are using FFT sweeps.
–221 Settings conflict; Signal
Track is turned off when
Zero Span is selected
Signal Track is not available when you have selected Zero
Span. So if Zero Span is entered while in Signal Track is On,
Signal Track is turned off.
–221 Settings Conflict; Span
limited to XXX
Err# Message Verbose/Correction Information
To Next Page
Loading...
Need help?
General
