132 N9030B PXA Signal Analyzer Service Guide
Instrument Messages
Condition Messages
Condition Errors 201 to 299, Signal Integrity
This series of errors corresponds to the bits in the
STATus:QUEStionable:INTegrity:SIGNal sub-register. The second column in the
table shows the corresponding bit.
An event with the error number shown in the table means the condition has
been detected. When the condition is cleared, an event with the error number
plus 1000 is generated. These error numbers can be seen in the Show Errors
screen, along with the DETECTED and CLEARED indicators.
For example, error 207 indicates a Burst Not Found condition has been
detected, error 1207 indicates that failure has been cleared.
This register is summarized as bit 0 of the STATus:QUEStionable:INTegrity
register. See section “Condition Errors 101 to 199, Measurement Integrity” on
page 128.
Err# Bit in
Status
Register
Message Error or
Warning
More Information
203 0 unused E
205 1 unused E
To Next Page
Loading...
Need help?
General
