Keysight Technologies N9030B User Manual

588 N9030B PXA Signal Analyzer Service Guide
Functional Tests
Amplitude Accuracy at 50 MHz
Testing Preamp Option (P03, P08, P13, P26)
Instruments containing Option P03, P08, P13, P26 must have the preamp
function turned on and tested.
Procedure
1. On the analyzer, press AMPTD Y Scale, More, Internal Preamp, Low Band.
2. Connect the equipment as shown in Figure 18-4 on page 586, using a
30 dB pad between the adaptor and the signal analyzer input.
3. Set the synthesized sweeper amplitude to the value listed in the Nominal
Source Amplitude column in Table 18-6.
4. Set the signal analyzer input attenuation to 0 dB.
5. Set the Span as listed in Table 18-6.
6. Record the synthesized sweeper amplitude, as measured by the power
meter, in the Power Meter Amplitude column of Table 18-6.
7. On the signal analyzer, press Restart.
8. Wait for the analyzer to finish averaging.
9. Press Peak Search.
10.Record the signal amplitude as measured by the analyzer in the measured
amplitude column of Table 18-6.
11.Calculate the signal amplitude accuracy using the following equation:
Amplitude Accuracy Error = Meas_amp + 30 dB - Power_meter
12.Record the results under the Amplitude Accuracy Error column of Table
18-6.
Table 18-6 Amplitude Accuracy Results (Option P03, P08, P13, P26)
Nominal
Source
Amplitude
(dBm)
Low- band
Preamp
Res BW
(kHz)
Span
(kHz)
Measured
Amplitude
Meas_amp
(dBm)
Power Meter
Amplitude
Power_meter
(dBm)
Amplitude
Accuracy
Error
(dB)
Test Limit
(dB)
-13 ON 1 106 ±1.30 dB

Keysight Technologies N9030B Specifications

General

Brand	Keysight Technologies
Model	N9030B
Category	Measuring Instruments
Language	English