N9030B PXA Signal Analyzer Service Guide 121
Instrument Messages
Event Messages
–124 Too many digits The mantissa of a decimal-numeric contained more than 255
digits, excluding leading zeros.
–128 Numeric data not allowed A legal numeric data element was found, but that is not a valid
element at this position in the command.
–130 Suffix error A problem was found in a suffix (units). The exact problem
cannot be specifically identified.
–131 Invalid suffix There is a syntax problem with the suffix. You need to use the
suffix (units) that are allowed by this command.
–134 Suffix too long The suffix contained more than twelve characters.
–138 Suffix not allowed A suffix was found after a numeric element that does not allow
suffixes (units).
–140 Character data error A problem was found with a character data element. The exact
problem cannot be specifically identified.
–141 Invalid character data Either the character data element contains an invalid character
or the element itself is not valid for this command.
–144 Character data too long The character data element contains more than twelve
characters.
–148 Character data not
allowed
A character data element that you sent is valid, but it is not
allowed in this point in the parsing.
–150 String data error A problem was found with a string data element. The exact
problem cannot be specifically identified.
–151 Invalid string data A string type of data element was expected, but it is invalid for
some reason. For example, an END message was received
before the terminal quote character.
–158 String data not allowed A string data element that you sent is valid, but it is not allowed
at this point in the parsing.
–160 Block data error A problem was found with a block data element. The exact
problem cannot be specifically identified.
–161 Invalid block data A block data element was expected, but it was invalid. For
example, an END message was received before the end length
was satisfied.
–168 Block data not allowed A legal block data element was found, but it is not allowed at this
point in the parsing.
–170 Expression error A problem was found with an expression data element. The exact
problem cannot be specifically identified.
–171 Invalid expression An expression data element is not valid. For example, there may
be unmatched parentheses or an illegal character.
Err# Message Verbose/Correction Information
To Next Page
Loading...
Need help?
General
