Kyocera Taskalfa Pro 15000c - Page 431

15-52
Setting up from System Menu > Network Settings
REST Protocol
Settings
Select whether to communicate using REST.
The default port number is 9080.
The setting will be changed after restarting the device or network.
Value: Off, On
REST over SSL Protocol
Settings
Select whether to communicate using REST over SSL.
The default port number is 9081.
The setting will be changed after restarting the device or network.
Value: Off, On
NOTE
• When selecting [On], it also requires a certificate for SSL. the default
certificate is the self-certificate of the machine.
• Set "SSL" to [On] in Security Settings.
SSL (page 15-65)
VNC (RFB) over
SSL
Protocol
Settings
This is set when starting up a VNC Viewer (E.g. RealVNC) to use Remote
Operation protected by SSL.
The default port number is 9063.
The setting will be changed after restarting the device or network.
Value: Off, On
NOTE
• When selecting [On], it also requires a certificate for SSL. The default
certificate is the self-certificate of the machine.
• Set "SSL" to [On] in Security Settings.
SSL (page 15-65)
VNC (RFB) Protocol
Settings
This is set when starting up a VNC Viewer (E.g. RealVNC) to use the Remote
Operation.
The default port number is 9062.
The setting will be changed after restarting the device or network.
Value: Off, On
Enhanced VNC
(RFB) over SSL
Protocol
Settings
This is set when starting up Command Center RX to use Remote Operation
protected by SSL.
The default port number is 9061.
The setting will be changed after restarting the device or network.
Value: Off, On
NOTE
• The default setting is [On].
• When selecting [On], it also requires a certificate for SSL. The default
certificate is the self-certificate of the machine.
• Set "SSL" to [On] in Security Settings.
SSL (page 15-65)
Item Description