19-51
Troubleshooting > Other Trouble
S
Remove originals in
the document
processor.
Are there any originals left in the
document processor?
Remove originals from the
document processor.
―
Replace all originals
and press [Continue].
—
Remove originals from the
document processor, put them
back in their original order, and
place them again. Select
[
Continue
] to resume printing.
Select [
Cancel
] to cancel the job.
—
Running security
function...
— Running security function.
Please wait.
—
*1 When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time
elapses. For details on Auto Error Clear, refer to the following:
Auto Error Clear (page 15-23)
Message Checkpoints Corrective Actions
Reference
Page
Scanner memory is
full.
*1
— Scanning cannot be performed
due to insufficient memory of the
scanner. Follow the instructions
on the screen.
—
Send error.
*1
— An error has occurred during
transmission. The job is
canceled. Select [End]. Refer to
Responding to Send Error for
the error code and corrective
actions.
page 19-37
Skewed originals or
multi originals fed at
once.
— See the caution attached on the
document processor and check
the originals. If the originals are
jammed, follow the instructions
on the screen to remove the
originals.
—
Staple is empty.
*1
Has the staple cartridge holder
run out of staples?
If the staples are depleted, the
machine will stop and the
location of staple depletion will
be indicated on the screen.
Leave the machine on and
follow the instructions to replace
the staple case. Select
[Continue] to print without
stapling. Select [Cancel] to
cancel the job.
page 17-13
page 17-15
Staple is empty.
(Manual Staple)
Has staple cartridge holder A
run out of staples?
Add staples to staple cartridge
holder A.
page 17-13
Message Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
