Lenovo ThinkSystem SR630 V3 - Page 248

2. Properly route and secure the cables in the server. Refer to detailed cable routing information for each
component in
Chapter 6 “Internal cable routing” on page 249.
3. Install the rear drive cage if you have removed it. See
“Install the 2.5-inch rear drive assembly” on page
199
.
4. Install the air baffle if you have removed it. See
“Install the air baffle” on page 78.
5. Install the top cover. See
“Install the top cover” on page 244.
6. Push the power supplies into the bays until they click into place.
7. Connect power cords to the server and turn on the server.
8. Update the Vital Product Data (VPD) of the system board assembly. See
“Update the Vital Product Data
(VPD)” on page 238
.
9. Optionally, enable Secure Boot. See
“Enable UEFI Secure Boot” on page 228.
Demo video
Watch the procedure on YouTube
Update the Vital Product Data (VPD)
Use this topic to update the Vital Product Data (VPD).
• (Required) Machine type
• (Required) Serial number
• (Optional) Asset tag
• (Optional) UUID
Recommended tools:
• Lenovo XClarity Provisioning Manager
• Lenovo XClarity Essentials OneCLI commands
Using Lenovo XClarity Provisioning Manager
Steps:
1. Start the server and press the key according to the on-screen instructions. The Lenovo XClarity
Provisioning Manager interface is displayed by default.
2. Choose System Summary. The “System Summary” tab page is displayed.
3. Click Update VPD, then, follow on-screen instructions to update the VPD.
Using Lenovo XClarity Essentials OneCLI commands
• Updating machine type
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> [access_method]
• Updating serial number
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n> [access_method]
• Updating system model
onecli config set SYSTEM_PROD_DATA.SysInfoProdIdentifier <system model> [access_method]
onecli config set SYSTEM_PROD_DATA.SysInfoProdIdentifierEx <system model> --override [access_method]
• Updating asset tag
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag> [access_method]
• Updating UUID
onecli config createuuid SYSTEM_PROD_DATA.SysInfoUUID [access_method]
238 ThinkSystem SR630 V3 User Guide