Cable routing with an SFF HBA/RAID adapter
The following table shows the mapping relationship between backplane connectors and processor board/
adapter connectors when an 8i SFF HBA/RAID adapter (Gen 3 or Gen 4) is installed.
The following figure illustrates the cable routing for the configuration of 4 x 2.5-inch front AnyBay drive bays
with an 8i SFF RAID adapter. Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Figure 269. Cable routing for 4 x 2.5-inch front AnyBay drive bays with an 8i SFF RAID adapter
Table 69. Mapping between backplane connectors and processor board/adapter connectors when an SFF HBA/RAID
adapter is installed
Backplanes From To
Front BP (SAS) SAS C0
Notes:
Chapter 6. Internal cable routing 313
To Next Page
Loading...
