• Gen 3 and Gen 4 SFF HBA/RAID adapters are slightly different in their connectors, but the cable routing
method is similar.
• To connect cables for RAID flash power module, refer to
“RAID flash power modules” on page 264.
Cable routing for 4 x 2.5-inch front SAS/SATA drive bays with an 8i CFF RAID adapter (Gen 3) installed
The following table shows the mapping relationship between backplane connectors and processor board/
adapter connectors when an 8i CFF RAID adapter (Gen 3) is installed.
Figure 270. Cable routing for 4 x 2.5-inch front SAS/SATA drive bays with an 8i CFF RAID adapter installed
314 ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
