Figure 290. Cable routing for 6 front SAS/SATA drives and 4 front AnyBay drives bays and a 16i SFF RAID adapter (Gen 3)
with 2 x 2.5 rear SAS/SATA drives installed
Table 90. Mapping between one front AnyBay and one rear SAS/SATA backplanes and an SFF HBA/RAID adapter
Backplane From To
Front BP (SAS)
1 SAS 0, SAS 1 1 C0, C1
Front BP (NVMe)
2 NVMe 2–3, 0–1
2 PCIe 1, 2
Front and Rear BP (SAS)
3 SAS 2 3 C2
4 SAS (rear) 4 C3
6 x 2.5'' SAS/SATA + 2 x 2.5'' AnyBay + 2 x 2.5'' NVMe (one processor)
See this section to understand the cable routing of 6 front SAS/SATA drives, 2 AnyBay drives and 2 front
NVMe drives.
Chapter 6. Internal cable routing 337
To Next Page
Loading...
