To connect cables for a 7mm drive backplane, refer to “7mm drive backplane” on page 270.
To connect power cables for a backplane for standard 2.5-inch or 3.5-inch drives, refer to
“Cable routing for
backplane power” on page 274
.
To connect cables for M.2 drives, refer to
“M.2 drive backplane” on page 267.
To connect signal cables for a backplane for standard 6 front SAS/SATA drives, 2 AnyBay drives and 2 front
NVMe drives, refer to the following cable routing scenarios depending on your server configuration:
•
“Cable routing for onboard configuration” on page 338
• “Cable routing with an SFF HBA/RAID adapter” on page 339
Cable routing for onboard configuration
The following tables show the mapping relationship between backplane connectors and processor board
connectors for onboard configuration.
338
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
