Figure 348. Cable routing for onboard configuration of 6 x 2.5'' SAS/SATA front drives and 4 x 2.5'' AnyBay front drives
Table 155. Mapping between one front AnyBay backplane and processor board for onboard configuration
Backplane From To
Front BP (SAS)
1 SAS 0–3 1 SATA 0
Front BP (power)
2 Power and sideband
Note
2 Power port for front BP
Front BP (SAS)
3 SAS 4–7, 8–9 3 SATA 1, 2
Front BP (NVMe)
4 NVMe 6–7
4 PCIe 2
5 NVMe 8–9
5 PCIe 1
Note: Different from the 10 x 2.5'' Anybay backplane (Gen 4), the new Gen 5 backplane has two connectors,
power and sideband, for power connection. The two connectors are placed closely, make sure that the two
are connected. Use the illustration above for guidance.
Cable routing with an SFF HBA/RAID adapter
The following tables show the mapping relationship between backplane connectors and a 16i SFF RAID
adapter (Gen 3 or Gen 4).
Chapter 6. Internal cable routing 413
To Next Page
Loading...
