Figure 354. Cable routing for six front SAS/SATA and four front AnyBay drives with a 16i CFF HBA/RAID adapter (Gen 4)
and two rear SAS/SATA drives installed
Table 161. Mapping between one front AnyBay and one rear SAS/SATA backplane and a CFF HBA/RAID adapter
Backplane/adapter
From To
Front BP (SAS)
1 SAS 0–3 1 C0
2 SAS 4–7 2 C1
3 SAS 8–9 3 C2
CFF RAID adapter
4 MB input
4 PCIe 3
5 C3 5 SAS (rear)
Front BP (power)
6 Power and sideband
6 Power port for front BP
Front BP (NVMe)
7 NVMe 6–7
7 PCIe 2
8 NVMe 8–9
8 PCIe 1
6 x 2.5'' SAS/SATA + 2 x 2.5'' AnyBay + 2 x 2.5'' NVMe (Gen 5)
See this section to understand the cable routing of six front SAS/SATA drives, two front AnyBay drives and
two front NVMe drives with the 10 x 2.5'' AnyBay backplane (Gen 5) installed.
To connect cables for a 7mm drive backplane, refer to
“7mm drive backplane” on page 270.
To connect cables for M.2 drives, refer to
“M.2 drive backplane” on page 267.
Chapter 6. Internal cable routing 419
To Next Page
Loading...
