To connect cables for rear NVMe drives, refer to “Rear NVMe backplane cable routing with 10 x 2.5'' AnyBay
backplane (Gen 5) installed” on page 273
.
To connect signal cables for a backplane for standard six front SAS/SATA drives, two AnyBay drives and two
front NVMe drives, refer to the following cable routing scenarios depending on your server configuration:
•
“Cable routing for onboard configuration” on page 420
• “Cable routing with an SFF HBA/RAID adapter” on page 421
• “Cable routing with a CFF HBA/RAID adapter” on page 422
Cable routing for onboard configuration
The following tables show the mapping relationship between backplane connectors and processor board
connectors for onboard configuration.
Figure 355. Cable routing for onboard configuration of six SAS/SATA drives and two AnyBay and two NVMe front drives
bays
Table 162. Mapping between one front AnyBay backplane and processor board for onboard configuration
Backplane From To
Front BP (SAS)
1 SAS 0–3 1 SATA 0
Front BP (power)
2 Power and sideband
2 Power port for front BP
Front BP (SAS)
3 SAS 4–7, 8–9 3 SATA 1
Front BP (NVMe)
4 NVMe 6–7
4 PCIe 2
420 ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
