Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 367
8400 StateLine C | Reference manual
Basic drive functions (MCK)
Holding brake control
The brake will also be activated automatically if quick stop is activated in the drive, e.g.
by a device command or as response to an error, and in the event of controller inhibit
or pulse inhibit.
After automatic brake activation and elapse of the brake application time, the
controller is inhibited automatically by the basic "Holding brake control" function.
Tip!
The 2/12 mode is the common mode to control the brake.
Modus 13: Semi-automatic control
From version 11.00.00
In this mode, brake release and brake application can be directly controlled via the input
bMBrakeReleaseBrake without special logic or automatic.
In contrast to the manual operation (mode 11)
the feedforward control is active in this mode, preventing a sagging e.g. in case of a
hoist.
the brake in this mode also closes when the controller is inhibited in order to prevent
the axis in a hoist from falling.
Related topics:
TroubleQSP
( 94)
Behaviour in case of pulse inhibit
( 377)
To Next Page
Loading...
