Lenze i410 - Page 301

30355 0x7693 EPM data: PU size
incompable Keypad display: EPM PU size inco
Cause Remedy Error type/response
The parameter sengs saved in the memory
module ar
e incompable with the inverter.
1.
Ex
ecute device command "Load default
sengs" 0x2022:001
(P700.01).
2.
Execute "Save user data" 0x2022:003
(P700.03) or "Save OEM data" 0x2022:006
(P700.06) device command.
Fault
•
The data have been loaded into the RAM
memory, but they are incompable.
30356 0x7694 EPM data: new PU size detected Keypad display: EPM ne
w PU size
Cause Remedy Error type/response
The parameter sengs saved in the memory
module c
omply with a dierent hardware.
Example: Memory module of an inverter with a
power of 3 kW is used in an inverter with a
power of 18.5 kW.
1.
Check par
ameter sengs.
2.
R
eset error.
3.
Execute "Save user data" 0x2022:003
(P700.03) or "Save OEM data" 0x2022:006
(P700.06) device command.
Fault
•
The da
ta have been loaded into the RAM
memory without being modied, and they
are compable.
•
The sengs loaded must be accepted by the
user (see remedy).
30357 0x7695 Invalid parameter changeover
conguraon Keypad display: InvalidChgovrCfg
Cause Remedy Error type/response
One or more parameters can no longer be used
f
or the "Parameter change-over" funcon.
1.
Check err
or message for parameter change-
over in 0x4047:001 (P756.01).
2.
Correct the list entry shown in 0x4047:002
(P756.02).
Warning
•
The par
ameter change-over funcon is
deacvated.
30358 0x7696 EPM data: unknown parameter found Keypad display: Unkn. P
ar in EPM
Cause Remedy Error type/response
The memory module contains parameter
sengs for one or several parameters that are
not kno
wn to the inverter.
Execute the "Save user data" 0x2022:003
(P700.03) device command. This reinialises
the user memory with the current parameter
sengs. In this way, parameter sengs that are
no longer required are automacally deleted.
Informaon
30359 0x7697 Parameter changes lost Keypad display: P
arameter loss
Cause Remedy Error type/response
A voltage failure has occurred and changed
par
ameter sengs that had not been saved yet
were available.
1.
Ex
ecute parameter sengs again.
2.
Ex
ecute device command "Save user data"
0x2022:003 (P700.03).
Fault
•
The parameter sengs changed have been
lost.
33045 0x8115 Time-out (PAM) Keypad display: Time-out (P
AM)
Cause Remedy Error type/response
Error message is not available for the inverter
i410.
No response
(congurable)
Seng parameters: 0x2552:004
33050 0x811A BACnet me-out Keypad display: B
ACnet me-out
Cause Remedy Error type/response
Error message is not available for the inverter
i410.
Fault (congurable)
Seng parameters: 0x2856:001
Diagnoscs and fault eliminaon
Error codes, causes and remedies
301