MIMAKI CFL-605RT - Chapter 6 Troubleshooting

This Section....
describes what to do if you think the unit is broken and gives the appropriate remedies for
each displayed error number.
It also describes the self-test functions.
Now What Do I Do?................................ 6-2
Adjusting the Tools................................. 6-3
Adjusting the Cutter ..................................6-3
Circle  Correction ..................................6-11
Troubleshooting.................................... 6-14
Unit does not operate when the power is
turned ON ...............................................6-14
Unit does not operate after the CAD data is
sent ........................................................6-14
An error occurs when the data is sent .... 6-14
Tool lifts up the paper .............................6-15
Drawn lines are broken or smudged ......6-15
No reciprocating movement ...................6-15
Problems Causing an Error Display ..... 6-16
Non-fatal Errors ......................................6-16
Status message ......................................6-19
Sample Cut........................................... 6-20
Perform SAMPLE CUT to Find out the Cause
of Cutting Error. ......................................6-21
CFL-605RT Specifications.................... 6-23
Chapter 6
Troubleshooting