MIMAKI CFL-605RT - Register Mark Detection Procedure

4-12
Detecting Register Marks
Register Mark Detection Procedure
1
Mount the workpiece.
2
Press in local mode.
• The mark search mode is selected.
3
Press the jog keys to accurately align the light pointer to the positions shown
below.
4
Press .
• Register mark detection starts.
• If SCALE is set to “BEFORE”, when is pressed, the screen shown at Step 5 appears before
register mark detection starts.
• An error message appears if the register marks cannot be detected. Mount the workpiece again.
5
After the register marks are detected, the SCALE
CORRECT screen appears.
(This example shows 4-point detection.)
• If the data lengths and detected lengths differ, use
to set them.
6
Press after setting.
• The local mode is selected.
• If SCALE is set to “before”, register mark detection starts.
• Press to disable the scale correction.
• If [SCALE] is set to OFF, the <SCALE SET> screen is
not displayed.
• If [MARK DETECT] its set to [2pt-X], the display for
inputting the Y length will not appear.
• If [DETECT] is set to “1pt” the <SCALE SET> screen
is not displayed.
<MARK DETECT> mm
X: +0000 . 0 Y: +0000 . 0
Type1
Light pointer point
<MARK DETECT> mm
X(1-2)=****.*