3-20
Setting the Close Time
After cutting (plotting) the data that was sent from PC, following operation starts automatically at the time that
had been set in advance.
• Data clear ( P.2-26)
• Automatic Head Retraction ( P.1-24)
• Vacuum Automatic OFF ( P.1-25)
• Multi-pass Cutting ( P.3-12)
1
Select [PLOT SETTING] of the set up menu.
(1) Press the key in LOCAL.
(2) Press to select [SET UP] and press the key.
(3) Press to select [PLOT SETTING].
(4) Press the key.
2
Press the jog key or to select [CLOSE
TIME], and ress the key.
3
Press the jog key or to select the set
value.
• Set values: 3 s to 30 s
4
Press the key.
• Press if you do not want to save the setting.
5
Press the key twice for terminating this function.
<PLOT SETT I NG>
CLOSE TIME : 3sec
<PLOT SETT I NG>
CLOSE T I ME : 10 s e c
To Next Page
Loading...
