MIMAKI CFL-605RT - Performing Sample Cuts

6-21
1
1
1
1
Troubleshooting
6
Sample Cut
Perform SAMPLE CUT to Find out the Cause of Cutting Error.
The pen number must assigned before conducting PATTERN CUT or SAMPLE CUT. ( P.3-9)
Set the following values as the initial values.
1
Set the origin at the point where you wish to run the sample cut
2
Press the key in the local mode.
3
Press the jog key or to select [SAMPLE
CUT] .
4
Press the key.
5
Press the jog key or to select the self test
items
• Set values: PATTERN CUT1, 2 / SAMPLE 0.5mm, SAMPLE 1.0mm,
SAMPLE1.5mm, SAMPLE BUFFER, CIRCLE CUT R=3~R=100
6
Press to draw the data.
• Press to cancel SAMPLE CUT.j\
Pen No. Model R1
1
Head B
Tool Reciprocating cutter 1 (Set a vibration to other than OFF)
2
Head B
Tool Roller 1
3
Head B
Too l CUTTER
4
Head B
Too l
Roller 2
5
Head A
Tool Swivel blade
6
Head A
Too l Pe n
<FUNCT ION>


SET UP [ ENT ]
FUNCTION
<FUNCT ION>


SAMPLE CUT [ ENT ]
<SELECT PATTERN>


PATTERN CUT1 [ENT]
<SELECT PATTERN>


PATTERN CUT2 [ENT]