MIMAKI CFL-605RT - Checking Registration Mark Sensor Functionality

4-16
Check the sensor for the registration mark detection
Prepare the sheet on which the registration mark is printed.
1
Make sure that the plotter is in local mode.
2
Enter the jog mode by pressing the jog key or
3
Move the tip of the pen to the registration mark detection position by pressing the
appropriate ones of the jog keys and .
• Perform registration mark detection at a position 1mm or more away from the registration mark.
4
Press the key to terminate the jog mode.
• The plotter returns to the local mode.
5
Press the key.
6
Select [MARK sensor] by pressing the jog key or
.
7
Press the key.
• If you move the head and sheet manually, you cannot perform the right response check. Be sure to
perform it via the following operations.
•
For conditions of already printed registration mark, refer to “Precautions when Creating Data
with Register Marks” ( P.4-2).
• Set the buzzer sound to “ON”. ( P.3-26) The registration mark detection sound is not made if the
buzzer sound is set to OFF.
< LOCAL>
A:SWIVEL
1 mm or
more away
: Mark detection position
Mark :
Type 1
Mark :
Type 2
<FUNCT I ON>


SET UP [ENT]
FUNCTION
<FUNCT I ON>


MARK S E N SOR [ E NT ]
<MARK SENSOR>


SENSOR OFS [ENT]