4-15
1
1
1
4
Register Mark Reading Functions
Confirm the following when failed in cutting correctly
8
Enter the corrected value (mm) by pressing the
for the X direction, or the for
the Y direction.
• If misaligned by +0.2 mm, enter "-0.2".
9
Press the key.
• Registering the compensation value.
10
Press the key twice for terminating this function.
• The setting values are kept in memory even when the power is turned off.
• The sensor offset value selected by this operation is not initialized by SETUP RESET operation.
<SENSOR OFFSET>
X=-0 . 2mm Y=-0 . 2mm
<MARK SENSOR>
SENSOR OFS [ENT]
To Next Page
Loading...
