MIMAKI CFL-605RT - Mounting the Reciprocating Cutter

1-17
1
Setup
5
6
5
6
Mounting Tools
Mounting the Reciprocating Cutter
Attach a reciprocating cutter to B unit.
Mounting the Reciprocating Cutter Blade
1
Use the 2.0 mm hexagonal wrench supplied to
loosen the stopper screw.
• Loosen the stopper screw on the cutter holder.
• Turn the cutter stopper counterclockwise to loosen it.
• Do not loosen the screw back side of the setscrew.
2
Firmly push the blade as far as possible into the
cutter holder.
• For safety, handle the blade with the tweezers supplied.
• Attention to the flat part of the holder, setscrews and the
direction of the blade and attach as shown in the figure.
3
Tighten the stopper screw and clamp the blade.
• Do not touch the blade with bare hands. This may cause injury.
• A reciprocating cutter holder is required to mount the reciprocating cutter.
For Unit B, Model R1
Name: Reciprocating Cutter Holder 07L (SPA-0260)
Blade: Carbide 2°x10 (SPB-0086)
Carbide blade 7x15 (SPB-0075)
Stopper
screw
Flat part
Stopper
screw