MIMAKI CFL-605RT - Cutting the same Data Again (Copy)

3-11
1
1
3
Useful Function
5
6
Cutting the Same Data Again (Copy)
Previously cut data can be cut again in offline status.
This eliminates the need to send the same data many times from the PC.
1
Clear the data ( P.2-26).
• Clear the data immediately before receiving the data to copy.
2
Cut the data to copy ( P.2-24).
3
Press to select local status.
4
Press a jog key to move the
origin ( P.2-23).
• Reset the origin to the position to be copied. Failure to reset the
origin results in cutting at the same position.
5
Press .
6
Press to copy the data.
• Press to cancel the copy.
• When copying is complete, the display reverts to the remote
status.
Head withdrawal follows the setting of [AFTER PLOT] - [AUTO
VIEW]. ( P.1-24)
• To cut once more, repeat the procedure from Step 4.
• Use DATA CLEAR to clear ( P.2-26) the receive buffer before receiving the data to be copied. If the
data is not cleared, the other data in the receive buffer will be copied.
<COCAL>
B:REC.CUTTER1
<COPY>
COPY [ ENT ]
<COPY> ****KB
B:REC.CUTTER1