3-29
1
1
3
Useful Function
5
6
Other Useful Functions
Setting a COMMAND
Setting a PRIORITY
When this plotter and the host computer make different settings on a same item, this function is used to set about
which of the two must be given priority to
1
Select [COMMAND SETTING] of the set up menu.
(1) Press the key in LOCAL.
(2) Press to select [SET UP] and press the key.
(3) Press to select [COMMAND SETTING].
(4) Press the key.
2
Press the jog key or to select [PRIORITY] .
3
Press the key.
4
Press the jog key or , select the item to be
set.
5
Press the key.
1
Press the jog key or
to select Setting.
• Set values:
HOST:
This is to give priority to the setting of host computer.
PANEL: This is to give priority to the setting of this plotter.
• If set other items, repeat the procedure from step 4 to 7.
6
Press the key.
• Press if you do not want to save the setting.
7
Press the key several times to end the setting.
SP; Pen selection command
VS; Pen lowering speed setting command
ZA; Pen lifting speed setting command
AS; Acceleration setting command
FS;、ZF;
Pen pressure setting command
ZO; Cutter blade compensation setting command
FUNCTION
<SET UP>
RS- 232C [ENT ]
<RS SETT I NG>
BAUD RATE : 9600
<PR I OR I TY>
ZO : HOST
<SET UP>
START MODE : REMOTE
To Next Page
Loading...
