2-27
1
2
Basic Operations
5
5
6
Turning the Power OFF
Before turning OFF the power, confirm that no data is being received and no un-output data remains.
1
Turn off the connected PC.
2
Press the power switch to turn the power OFF.
• Push the power switch located on the operation panel.
• Power lamp goes off and power turns off.
3
Set the power switches located on the right side
of this machine to the “O” side.
Checking Uncut Data
To cut the data
(1) Press to select remote status.
(2) Received data volume is displayed and cutting (drawing) starts.
To delete the data
(1) Press to select local status.
(2) Clear the data. ( P.2-26)
To Next Page
Loading...
