4-10
Detecting Register Marks
The unit can automatically detect register marks printed on the workpiece to cut round outlines of designs
printed on the workpiece.
Using the Light Pointer to Check the Workpiece Tilt
When press key in jog mode, the light pointer lights.
By pressing the jog keys to move the light pointer between points TP1 and TP2, the tilt of the workpiece can be
checked from the light-pointer line. Adjust the tilt of the workpiece to this line.
• If the workpiece has curled, flatten it out.
• If using cutting software that does not offer register mark functions, ensure that the areas between
TP1 and TP3 and between TP1 and TP2 are free of images and dirt.
Workpiece tilt
Line traced by
light pointer
To Next Page
Loading...
