1-7
1
Setup
5
6
6
Cable Connections
Connecting the Power Cable
After connecting the interface cable, you must connect the power cable.
Connect the power cable with the plug outlet of the following power
specifications.
• Voltage : AC100 - 240V ± 10%
• Frequency : 50/60Hz
Connecting the Interface Cable
The unit offers an RS-232C interface and USB interface as standard.
Use an RS-232C interface cable recommended by Mimaki or one that suits the PC you are using.
Turn off the plotter and PC before connecting the RS-232C interface cable.
• Turn OFF ( P.2-27) the power before connecting the vacuum signal cable, RS-232C interface
cable, or USB interface cable. Failure to turn off the power may result in electric shocks or damage to
the unit.
• If use in Japan, use at single-phase 100V -
120V.
If use at single-phase AC200V, please consult
your service engineer.
• Be sure to connect
the ground wire.
• Using without the
ground wire causes the
damage of this device
and electric shock that
may be very
dangerous.
• Regarding the use of
two polar plug outlet,
you must connect the
auxiliary ground
adapter to the plug of
power cable.
• Earth the green wire (ground wire) of the ground
adapter. If you cannot, consult with an
electrician.
Connect the
RS-232C
interface cable.
Connect the LAN connector.
Connect the USB
interface cable.
To Next Page
Loading...
