MIMAKI CFL-605RT - Interlock between Remote Key and Vacuum Key

1-26
Setting the Vacuum
Interlock between Remote Key and Vacuum Key
The vacuum key can be turned on/off automatically using the remote key.
If a cutting operation is performed without activating the vacuum, the workpiece may float and hinder the cutting
operation.
This symptom can be prevented by selecting "REMOTE ON".
This function is available from firmware version V1.50.
1
Select [PLOT SETTING] of the set up menu.
(1)Press the key in LOCAL.
(5) Press to select [SET UP] and press the key.
(6) Press to select [PLOT SETTING].
(7) Press the key.
2
Press the jog key or to select [BEFORE
PLOT], and ress the key.
3
Press the key.
4
Press the jog key or to select [REMOTE
ON].
• Set values: N/C , REMOTE ON
5
Press the key.
• Press if you do not want to save the setting.
6
Press the key twice for terminating this function.
Item Set value
REMOTE ON
When the remote mode is selected by pressing the remote key, the
vacuum is automatically turned on.
When the offline mode is selected using the remote key, the vacuum is
turned off.
N/C
You can turn on/off the vacuum using the vacuum key on the operation
panel.
FUNCTION
<PLOT SETT I NG>


BEFORE PLOT [ ENT ]
<BEFORE PLOT>
VACUUM ON:N/C
N
<BEFORE PLOT>
VACUUM ON : REMOTE ON