4-2
Precautions when Creating Data with Register Marks
Several restrictions apply when creating data with register marks.
To get the best out of the register mark functions, carefully read the precautions below to gain the knowledge
required when creating register marks.
Size of Register Marks
See "Guide to Register Mark Separation and Register Mark Size" ( P.4-5) for guidelines on a side length of
register marks with respect to the data.
• The register marks described here are used to detect the work orientation and the lengths of the X
and Y axes. They are not crop marks.
• Set a side length of the
register mark between
5 mm and 30 mm.
To Next Page
Loading...
