MIMAKI CFL-605RT - Chapter 4 Register Mark Reading Functions

This Section....
... describes the basic operations, such as mounting tools and workpieces.
Precautions when Creating Data with
Register Marks ....................................... 4-2
Size of Register Marks ............................4-2
Permitted Arrangements of Register Marks
and the Design .........................................4-3
Prohibited Drawing Areas around Register
Marks ........................................................4-3
Guide to Register Mark Separation and
Register Mark Size ...................................4-5
Register Mark Colors ................................4-6
Bleeding or Smudging of Register Marks . 4-6
Setting Register Mark Detection............. 4-7
Precautions Related to Register Mark
Detection ..................................................4-7
Setting Register Mark Detection ...............4-9
Detecting Register Marks ..................... 4-10
Using the Light Pointer to Check the
Workpiece Tilt .........................................4-10
Setting height of register mark ................4-11
Register Mark Detection Procedure .......4-12
Continuous Cutting of Register Marks. 4-13
Confirm the following when failed in
cutting correctly .................................... 4-14
Alignment of MARK SENSOR ................4-14
Check the sensor for the registration mark
detection .................................................4-16
Correct the light pointer position .............4-19
Setting of the back side cut offset ...........4-20
Chapter 4
Register Mark Reading Functions