MIMAKI CFL-605RT - Page 71

3-3
1
1
3
Useful Function
5
6
List of SET UP Functions
Function name Set value Default Outline
START MODE( P.3-27) LOCAL, REMOTE LOCAL
Set the mode after the power is turned on.
MM/INCH( P.3-17) mm, inch mm
This is to select the unit with which you
want to display the length.
JOG SETTING( P.3-28)
JOG
STEP
0.1mm, 1.0mm
(1/16, 1/256 inch)
0.1mm
(1/254inch)
This is to set the moving amount of
carriage via the jog key.
INTERFACE
RS-232C
(P.3-32)
BAUD RATE 1200~38400bps 38400
DATA BITS 7, 8 bit 8bit
PARITY NON, EVEM, ODD NON
STOP BITS 1, 2 1
HANDSHAKE
HARD, ENQACK,
X-PRM, SOFT
HARD
NETWORK
(P.3-34)
IP Address
The IP address currently used by this
machine is displayed.
MAC Address
The MAC address currently used by this
machine is displayed.
DHCP
ON
ON
When it is ON, the IP address given by
the DHCP server is used.
OFF
AutoIP
ON
ON
When it is ON, the IP address is determined
by the AutoIP protocol. However, DHCP is
ON, DHCP has priority.
OFF
IP Address
*1
*1. Settable when both of DHCP and AutoIP are [OFF]
Set the IP address used by this
machine.
Def.Gateway
*2
*2. Settable only when Auth. is not OFF
Set the default gateway used by this
machine.
DNS Address
*2
Set the DNS server address used by
this machine.
SubNetMask
*2
Set the digit number of the subnet mask
used by this machine.
EVENT MAIL
(P.3-36)
Delivery
ON
OFF
When the set event occurs, the function
to send the e-mail becomes ON.
OFF
When the set event occurs, the function
to send the e-mail becomes OFF.
EVENT
Plot Start
Event
ON
OFF
Set whether you send/ do not send the
e-mail at the start of plotting.
OFF
Plot End
Event
ON
OFF
Set whether you send/ do not send the
e-mail at the end of plotting.
OFF
Error
Event
ON
OFF
Set whether you send/ do not send the
e-mail when an error occurs.
OFF
Warning
Event
ON
OFF
Set whether you send/ do not send the
e-mail when a warning occurs.
OFF
Mail Addr.
Alphanumeric
characters and
symbols (within
96characters)
Set the e-mail address towhich you
send the event mail.
Subject
Alphanumeric
characters and
symbols (within
8characters)
Set the characters to write inthe subject
of the event mail.