MIMAKI CFL-605RT - Page 81

3-13
1
1
3
Useful Function
5
6
Setting Multi-pass Cutting
7
Press , select the number of times to set
the cut press value and press .
8
Set the cut press value by pressing the jog key
and press the .
• The press value settings are saved.
• Press if you do not want to save the settings.
• The set values differ according to the unit.
REC.CUTTER/CUTTER/ROLLER: 500 g to 1500 g
SWIVEL: 30 g to 1000 g
9
Repeat steps 7-8 to set the pressure value for each cut number.
• In order to make the multi-pass cutting with FineCut function, set “Off” in step 6 and set at the output
setting in FineCut.
• If the multi-pass cutting is set in both FineCut and the machine, the number will be duplicated.
Example) 3times in the machine side and 2 times in FineCut will be 6 times in total
• If the multi-pass cut is set, the drawing starts from the roller. After the cutting of the roller is finished,
the drawing of the reciprocating cutter, eccentric cutter and tangential cutter follow.
<MULT I PASS>


2nd PRESS: 1000g
<MULT I PASS>
2nd PRESS: 1200g