Minebea CSD-912B - Page 111

91
Measurement
5
5.4. Measurement in sequential mode
7KHÀRZRIPHDVXUHPHQWLQVHTXHQWLDOGLVFKDUJHPRGHLVDVIROORZV
Corresponding state display lamp lights according to judgment results.
- Discharged [NET]* < setting value of [FINAL] - setting value of [UNDER]: The [UNDER]
lamp lights.
- Discharged [NET]* > setting value of [FINAL] + setting value of [OVER]: The [OVER] lamp
lights.
6HWWLQJYDOXHRI>),1$/@VHWWLQJYDOXHRI>81'(5@GLVFKDUJHG>1(7@VHWWLQJYDOXHRI
[FINAL] + settings value of [OVER]: The [OK] lamp lights.
- Discharged [GROSS] or [NET]* > setting value of [FULL]: The [FULL] lamp lights.
*>1(7@7KHORDGH[FOXGLQJWKHZHLJKWRIWKHFRQWDLQHU
POINT
2QFHIXOOÀRZPHGLXPÀRZRUGULEEOHÀRZVWRSVGLVFKDUJHZLOOQRWVWDUWXQWLOWKH
next measurement starts.
,I>35(/,0@RI>%5$1'&2'(@KDVEHHQVHWWRIXOOÀRZLVQRWH[HFXWHG
,I>35(/,0@RI>%5$1'&2'(@KDVEHHQVHWWRPHGLXPÀRZLVQRWH[HFXWHG
- You can change the comparative target for the value of [ZERO BAND] and
[FULL]. Refer to "5.11.2. Comparative target settings of zero band" and "5.11.3.
Comparative target settings of full" for more information.
'LVFKDUJHG>1(7@VHWWLQJYDOXHRI>),-
NAL] - setting value of [PRELIMINARY2]
'LVFKDUJHG>1(7@VHWWLQJYDOXHRI>),-
NAL] - setting value of [PRELIMINARY1]
>*5266@RU>1(7@VHWWLQJYDOXHRI>=(52%$1'@
Measurement start
'LVFKDUJHG>1(7@VHWWLQJYDOXHRI
[FINAL] - setting value of [F-FALL]
Measurement is complete, and judgment
RIZHLJKLQJYDOXHV
The [ZERO BAND] lamp lights.
The [F. FLOW] lamp is turned off, and full
ÀRZVWRSV
The [M. FLOW] lamp is turned off, and [M.
FLOW] stops.
The [D. FLOW] lamp is turned off, and
GULEEOHÀRZVWRSV
The [FINISH] lamp lights.
The [F. FLOW], [M. FLOW], and [D. FLOW]
lamp light.
)XOOÀRZPHGLXPÀRZDQGGULEEOHÀRZ
start.