Minebea CSD-912B - Wiring of Strain Gage Based Transducers; 6-Wires Type Wiring Cable

2.2. Wiring of strain gage based transducers
7
Wiring
2
2.2. Wiring of strain gage based transducers
To start measurement using CSD-912B, you need to connect it with a strain gage based
transducer such as a load cell and a pressure sensor.
We describe here an example of connecting CSD-912B with load cells. Please proceed with
those procedures similarly for connection with other strain gage based transducers, too.
2.2.1. 6-wires type wiring cable
When you use a 6-wires type wiring cable to connect CSD-912B with a load cell, perform
wiring as follows.
POINT
6KRUWRXWWKHUHPRWHVHQVLQJLQSXW251DQGWKHUHPRWHVHQVLQJLQSXW±%/.
near the main body of the load cell. If you short out them near CSD-912B, 6-wires
type wiring does not work properly.
- If the 6-wires type wiring cable is 100 m or more, the accuracy may not be
covered under warranty since the remote sensing function of CSD-912B does not
ZRUNVXI¿FLHQWO\GXHWRWKHUHVLVWDQFHRIWKHFDEOH
7RGLVSOD\WKHWHQVLOHGLUHFWLRQRIDWHQVLRQW\SHDQGFRPSUHVVLRQWHQVLRQW\SH
ORDGFHOOLQSRVLWLYHYDOXHVFRQQHFWWKHORDGFHOOVLJQDO*51DQGWKHORDG
FHOOVLJQDO±%/8ZLWKWKHWHUPLQDO%DQG'UHVSHFWLYHO\RIWKHORDGFHOOWHUPLQDO
board. If the colors of your wires are different from those of Minebea’s standard
FDEOHVUHIHUWRWKHFHUWL¿FDWHRIWKHVWUDLQJDJHEDVHGWUDQVGXFHUWRXVH
/RDGFHOOH[FLWDWLRQ5('
5HPRWHVHQVLQJLQSXW251
5HPRWHVHQVLQJLQSXW%/.
/RDGFHOOH[FLWDWLRQ:+7
/RDGFHOOVLJQDO*51
/RDGFHOOVLJQDO%/8
6KLHOG<(/
/RDGFHOO
(;&
SIG- SIG+
(;&