Minebea CSD-912B - Measurement in Nozzle Control Mode; Settings before Measurement; Mode

111
Measurement
5
5.7. Measurement in nozzle control mode
5.7. Measurement in nozzle control mode
&6'%FRQWUROVQR]]OHSXOOLQJXSGRZQWR¿OOWKHFRQWDLQHUZLWKWKHPHDVXUHGREMHFW
XVLQJDZHLJKLQJKRSSHUZLWKDQR]]OH
%HIRUHPDNLQJDPHDVXUHPHQWHQWHUQHFHVVDU\VHWWLQJVLQDGYDQFHIRUPHDVXUHPHQWLQ
nozzle control mode.
POINT
- The nozzle control mode is available only if [CONTROL MODE] is [BATCH
MODE].
5.7.1. Settings before measurement
7RPDNHDPHDVXUHPHQWLQQR]]OHFRQWUROPRGHDIWHUHQWHULQJWKHQRUPDOVHWWLQJVRI
>6(48(17,$/02'(@ĺ6HWWLQJVEHIRUHPHDVXUHPHQWVHWWKHIROORZLQJLWHPV
- [OPERATION OF NOZZLE]
>%$7&+67$57'(/$<7,0(5@ZDLWLQJWLPHIRUQR]]OHGRZQ
Set [OPERATION OF NOZZLE] and [BATCH START DELAY TIMER] on Sequence control
VFUHHQ7DS>6(48(1&(&21752/@RQ>0(18@WRGLVSOD\6HTXHQFHFRQWUROVFUHHQ
POINT
- In nozzle control mode, [BATCH START DELAY TIMER] is the settings of the
ZDLWLQJWLPHIRUQR]]OHGRZQ
[OPERATION OF
NOZZLE]
Waiting time for
QR]]OHGRZQ