Minebea CSD-912B - Page 132

112
Measurement
5
5.7. Measurement in nozzle control mode
(1) [OPERATION OF NOZZLE] settings
6HWWKHIROORZLQJLWHPVUHODWHGWRQR]]OHRSHUDWLRQ
- Whether to start measurements in nozzle control mode.
:KHWKHUWRVWRSWKHPHDVXUHPHQWZKHQWKHQR]]OHWRXFKHVWKHFRQWDLQHU
:KHWKHUWRSUHYHQWWKHQR]]OHIURPEHLQJSXOOHGGRZQDWWKHMXGJPHQWRIWKHLQSXWLQ
VXSSOHPHQWDU\ÀRZPRGH
1) Set [NOZZLE CONTROL]
1. Tap [NOZZLE CONTROL].
7KHVFUHHQWRVHW>12==/(&21752/@ZLOOEH
displayed.
2. Tap [VALID]/[INHIBIT].
6HWWLQJ>9$/,'@PDNHVWKHQR]]OHEHLQJSXOOHGGRZQ
DWWKHVWDUWRIPHDVXUHPHQWDQGPDNHVWKHQR]]OH
EHLQJSXOOHGXSDWWKHHQGRIGULEEOHÀRZ
Default: [INHIBIT]
3. Tap [OK].
[NOZZLE CONTROL] has been set, and
>23(5$7,212)12==/(@VFUHHQZLOOEH
displayed.
2) Set the nozzle contact protection
1. Tap [CONTACT STOP SEQUENCE].
The screen to set [CONTACT STOP SEQUENCE]
ZLOOEHGLVSOD\HG
2. Tap [VALID]/[INHIBIT].
6HWWLQJ>9$/,'@VWRSVWKHPHDVXUHPHQWZKHQWKH
QR]]OHEHLQJSXOOHGGRZQWRXFKHVWKHFRQWDLQHUDQG
WKHZHLJKLQJYDOXHH[FHHGVWKHVHWWLQJYDOXHRI
[ZERO BAND].
Default: [INHIBIT]
3. Tap [OK].
[CONTACT STOP SEQUENCE] has been set, and
>23(5$7,212)12==/(@VFUHHQZLOOEH
displayed.