Minebea CSD-912B - BCD Output; RS-232 C Interface

274
Troubleshooting
11
11.1. Trouble causes and corrective measures
11.1.7. BCD output
Phenomenon Cause Action
Signals are not
transmitted.
The BCD output has been
incorrectly wired.
Correctly wire the BCD output with the external
HTXLSPHQWĺ%&'RXWSXWFRQQHFWRU
SLQDUUDQJHPHQW
An output other
than BCD is
output.
The functions related to
the BCD output of CSD-
912B have not been set
according to the
VSHFL¿FDWLRQVRIWKH
H[WHUQDOHTXLSPHQW
Set the functions related to the BCD output of
&6'%DFFRUGLQJWRWKHVSHFL¿FDWLRQVRI
WKHH[WHUQDOHTXLSPHQW
ĺ%&'RXWSXWVHWWLQJ
Intended values
are not output.
The BCD output target has
been incorrectly set.
Correctly set the BCD output target
ĺ2XWSXWWDUJHWVHWWLQJ
The BCD output
does not
change.
The BCD output has been
held.
Disable the BCD output hold.
11.1.8. RS-232C interface
Phenomenon Cause Action
Signals are not
transmitted.
The RS-232C interface
has been incorrectly wired.
Correctly wire the RS-232C interface with the
H[WHUQDOHTXLSPHQWĺ56&
FRQQHFWRUSLQDUUDQJHPHQW
The communication
protocol has been
incorrectly set.
Set the communication protocol according to
WKHVSHFL¿FDWLRQVRIWKHKRVWĺ
&RPPXQLFDWLRQVHWWLQJ
Command data have been
incorrectly set.
&RUUHFWO\VHWFRPPDQGGDWDĺ
&RPPDQGPRGHGDWDIRUPDWV
Communication
cannot be
controlled.
7KHFRPPXQLFDWLRQÀRZ
has been controlled by the
host.
0DNHVHWWLQJVVRWKDWWKHFRPPXQLFDWLRQÀRZ
is not controlled on the host side.
Intended values
are not output
in stream mode.
The target to be output in
stream mode has been
incorrectly set.
Correctly set the output target for the stream
PRGHĺ6WUHDPSULQWRXWSXWWDUJHW
VHWWLQJ